ViewSonic PJD5351 - DLP Projector User's Guide download pdf (Page 14)

Introduction10

Remote control effective range

Infra-Red (IR) remote control sensor is located on

the front of the projector. The remote control must be

held at an angle within 30 degrees perpendicular to

the projector's IR remote control sensor to function

correctly. The distance between the remote control

and the sensor should not exceed 8 meters (~ 26

feet).

Make sure that there are no obstacles between the

remote control and the IR sensor on the projector that

might obstruct the infra-red beam.

Replacing the remote control battery

CAUTION

• Avoid excessive heat and humidity.

• There may be battery damage if the battery is incorrectly replaced.

• Replace only with the same or equivalent type recommended by the battery manufacturer.

• Dispose of the used battery according to the battery manufacturer’s instructions.

• Never throw a battery into a fire. There may be danger of an explosion.

• If the battery is dead or if you will not be using the remote control for a long time, remove

the battery to prevent damage to the remote control from possible battery leakage.

1. Pull out the battery holder.

Please follow the illustrated instructions. Push and hold the locking arm while pulling

out the battery holder.

2.Insert the new battery in the holder. Note the positive polarity should face outward.

3.Push the holder into the remote control.

http://www.pureglare.com.au

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

No comments

ViewSonic PJD5351 - DLP Projector User's Guide Page 14