ViewSonic PJD5351 - DLP Projector User's Guide download pdf (Page 37)

Operation 33

Adjusting the sound level

To adjust the sound level, press Volume +/- on the remote control, or:

1. Repeat steps 1-2 above.

2. Press to highlight Volume and press / to select a desired sound level.

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The

following settings do not affect the projection settings, operation, or performance.

• Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets

the length of time the OSD will remain active after your last key press. The time length

ranges from 5 to 30 seconds in 5-second increments. Use / to select a suitable time

frame.

• Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the

OSD position in five locations. Use / to select a preferred position.

• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the

OSD menus. Use / to select your language.

• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be

displayed during projector start-up. Use / to select a screen.

Shutting down the projector

1. Press POWER and a confirmation message

displays prompting you.

If you don't respond in a few seconds, the

message will disappear.

2. Press POWER a second time. The

POWER indicator light flashes blue, the

projection lamp shuts down, and the fans will

continue to run for approximately 90 seconds

to cool down the projector.

3. Disconnect the power cord from the wall

socket if the projector will not be used in an

extended period of time.

CAUTION

• To protect the lamp, the projector will not respond

to any commands during the cooling process.

• To shorten the cooling time, you can also activate the Quick Cooling function. See "Quick

Cooling" on page 38 for details.

• Do not unplug the power cord before the projector shutdown sequence is complete or

during the 90-second cooling down process.

• If the projector is not properly shut down, to protect the lamp, when you attempt to re-start

the projector, the fans will run for a few minutes to cool down. Press POWER again to

start the projector after the fans stop and the POWER indicator light flashes blue.

http://www.pureglare.com.au

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 64 65

No comments

ViewSonic PJD5351 - DLP Projector User's Guide Page 37