ViewSonic PJ551D - XGA DLP Projector User's Guide download pdf (Page 24)

21 ViewSonic PJ500/PJ550/PJ501/PJ551

Troubleshooting

OSD Messages

The messages as described below may appear on the screen at POWER ON. Take the appropriate

measures when such messages appear.

This message is cleared automatically after approximately three minutes, and appears every time POWER is switched

ON.

Indicator Messages

The POWER indicator, LAMP indicator, and TEMP indicator are either lit, unlit or blinking as

explained in the table below.

Table 10: OSD Messages

Screen Message Meaning or Action Required

CHANGE THE LAMP. AFTER

REPLACING LAMP, RESET THE LAMP

TIME.

The lamp will reach the end of its life in 300 hours. POWER is switched off

automatically when the lamp reaches the end of its life. prepare a new lamp

for installation.

Always reset the lamp timer after replacing the lamp.

CHANGE THE LAMP. AFTER

REPLACING LAMP, RESET THE LAMP

TIME. THE POWER WILL TURN OFF

AFTER ** HR.

The lamp will reach the end of its life in ** hours. POWER will be switched

OFF automatically in ** hours. Replace the lamp as shown in "Replacing

the Lamp" on page 19.

Always reset the lamp timer after replacing the lamp.

CHANGE THE LAMP. AFTER

REPLACING LAMP, RESET THE LAMP

TIME. THE POWER WILL TURN OFF

AFTER 0 HR.

The lamp has reached the end of its life. POWER will be switched OFF in a

few minutes.

Switch POWER OFF immediately and replace the lamp as shown in

"Replacing the Lamp" on page 19.

Always reset the lamp timer after replacing the lamp.

NO INPUT IS DETECTED

ON ***

No input signal found.

Check signal input connections and signal sources.

SYNC IS OUT OF RANGE ON ***

The horizontal or vertical frequency of the input signal is not within the

specified range.

Check the specifications of the equipment and the signal source.

CHECK THE AIR FLOW

The internal temperature has risen.

Switch POWER OFF, and wait 20 minutes until the equipment cools.

Check the following and switch POWER ON again.

• Are the ventilation openings blocked?

• Is the air filter dirty?

• Is the ambient temperature in excess of 95°F (35°C)?

Table 11: Indicator Messages

POWER

indicator

LAMP

indicator

TEMP

indicator

Meaning or Action Required

Lights orange Turns off Turns off The Standby mode has been set.

Blinks green Turns off Turns off Warming up. Please wait.

Lights green Turns off Turns off ON. Normal operation possible.

Blinks orange Turns off Turns off Cooling. Please wait.

Blinks red - - Cooling. Please wait.

The error is found. Take the appropriate measures when the POWER

indicator ceases blinking.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

ViewSonic PJ551D - XGA DLP Projector User's Guide Page 24

Comments to this Manuals

Related products and manuals for Data projectors ViewSonic PJ551D - XGA DLP Projector