ViewSonic PJ1065-2 User's Guide download pdf (Page 20)

18 ViewSonic PJ1065

Replacing the Lamp

Switch the projector OFF, remove the power cord from the power

outlet, and wait at least 45 minutes for the unit to cool.

Prepare a new lamp.

Check that the projector has cooled sufficiently, and gently turn it

upside down.

Loosen the screw as shown in the diagram, and remove the lamp

cover.

Loosen the two screws, and gently remove the lamp while holding

the grips. Touching the inside of the lamp case may result in

uneven coloring.

Install the new lamp and tighten the two screws firmly. Also

steadily push the opposite side of the screwed lamp into the unit.

Replace the lamp cover in position and tighten the screw firmly.

Gently turn the projector right-side up.

CAUTION

• Ensure that screws are tightened properly. Screws not tightened

fully may result in injury or accidents.

• Do not use the projector with the lamp cover removed.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp. When the lamp has been replaced after the LAMP

indicator is red, or the CHANGE THE LAMP message is displayed, complete the following opera-

tion within ten minutes of switching power ON. The power will be turned off automatically if over

10 minutes.

Switch power ON, and press the RESET button, for approximately three seconds. The ‘LAMP

xxxx hr’ message will appear on the lamp timer on the bottom of the screen.

Press the MENU button on the remote control transmitter, or the RESET button on the control

panel, while the lamp timer is displayed. The ‘LAMP xxxx □

→

0 ■ CANCEL’ message will

then appear.

Press the and select 0,and wait until the timer display is cleared.

NOTE:

• Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always when

replacing the lamp. The message functions will not operate properly if the lamp timer is not reset

correctly.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

No comments

ViewSonic PJ1065-2 User's Guide Page 20