Viewsonic Projector PJ250 User Manual download pdf (Page 16)

ViewSonic PJ250 14

Replacing the Lamp Cartridge

PREPARATION

To prevent scratches place the lamp on a soft cloth.

Disconnect the power cable.

Turn the projector upside down.

Remove the lamp cover.

(1) Turn the screw that fastens the lamp cover

counterclockwise until it turns freely. (The screw

will not come out.)

(2) Lift the lamp cover a little and pull it off in the direction of the arrow.

WARNING

• The Lamp Cartridge should only be replaced after the unit has been turned off, cooled down for

60 minute and the power cord has been unplugged. Replacement of the lamp cartridge during

operation or immediately after operation stops may cause burns due to high temperature.

• Do not remove any screws other those specified.

• Do not touch the lamp with bare hands. Doing so could shorten the life of the lamp.

• If the lamp has reached the end of its usable life, the lamp bulb may shatter. If the lamp

shatters, contact ViewSonic Customer Support center immediately.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

No comments

Viewsonic Projector PJ250 User Manual Page 16