ViewSonic E72 User's Guide download pdf (Page 2)

Compliance Information

FCC NOTICE

The following statement applies to all products that have received FCC approval.

Applicable products bear the FCC logo, and/or an FCC ID in the format FCC ID: GSS-

VS14905 on the product label.This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) This device must accept any interference received,

including interference that may cause undesired operation. This mobiledevice has

been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequencyenergy and, if not installed and used

in accordance with the instructions, may cause harmful interferenceto radio

communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for

compliance could void theuser’s authority to operate the equipment. The antenna(s)

used for this transmitter must not be colocated or operating in conjunction with any

otherantenna or transmitter.

FCC SAR information

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth an

uncontrolled environment. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

The device was tested and complies to measurement standards and procedures

specified in FCC OET Bulletin 65, Supplement C

RF Exposure Information (SAR)

This device meets the government’s requirements for exposure to radio waves.

This device is designed and manufactured not to exceed the emission limits for

exposure to radio frequency (RF) energy set by the Federal Communications

Commission of the U.S. Government.

The exposure standard employs a unit of measurement known as the Specific

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for SAR

are conducted using standard operating positions accepted by the FCC with the EUT

transmitting at the specified power level in different channels.

The highest SAR value for the device as reported to the FCC is . W/kg when

placed next to the body.

5390

1 2 3 4 5 6 7 ... 44 45

Comments to this Manuals

No comments

ViewSonic E72 User's Guide Page 2

Comments to this Manuals

Related products and manuals for Tablets ViewSonic E72