ViewSonic VIEWPAD 100 - VIEWPAD 100 User's Guide download pdf (Page 2)

Compliance Information

FCC Statement

The following statement applies to all products that have received FCC approval. Applicable

products bear the FCC logo, and/or an FCC ID in the format FCC ID: GSS-VS14445G on

the product label.This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation. This mobiledevice has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequencyenergy and, if

not installed and used in accordance with the instructions, may cause harmful interferenceto

radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modications not expressly approved by the party responsible for compliance

couldvoid theuser’s authority to operate the equipment.The antenna(s) used for this

transmitter must not be colocated or operating in conjunction with any otherantenna or

transmitter.

FCC SAR information

FCC Radiation Exposure StatementThis equipment complies with FCC RF radiation

exposure limits set forth an uncontrolled environment. This transmitter must not be co-located

or operating in conjunction with any other antenna or transmitter.The device was tested

and complies to measurement standards and procedures specied in FCC OE Bulletin 65,

Supplement C.

Canada Statement

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is

subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause undesired

operation of the device.

1 2 3 4 5 6 7 ... 36 37

No comments

ViewSonic VIEWPAD 100 - VIEWPAD 100 User's Guide Page 2