ViewSonic VC320 User's Guide download pdf (Page 12)

Section 2

Getting Started

Loading the Battery

Before using the camcorder, you must load the Lithium-ion

rechargeable battery come within the package.

1. Insert the battery according to the correct polarity marks ( + or -).

2. Close the battery cover rmly.

Charge your battery

You must use the supplied AC charger or the USB cable. The camcorder

must be turned OFF. The blinking light conrms the camcorder is currently

charging, and the light becomes constant after the charging is completed. In

AC charging Mode, the light will turn itself off automatically after 3~5 minutes

. The full charge time is about 4 to 5 hours. (Actual charging time may vary. It

depends on the battery conditions.)

Inserting and Removing an SD Card (Optional)

The camcorder comes with an internal memory that allows you to store photos and videos. You can

expand the memory capacity by using an optional SD memory card.

1. Insert the memory card into the slot. Please refer to the gure on

the right side.

2. To remove the installed SD card, press the card inward to release it.

3. When the card pops out, gently remove it from its slot.

4. Recommended memory capacity: 1GB or above.

Note

• When a memory card is tted, videos/photos are saved to the card rather than the built-in

memory.

• ProtectingDataonanSDCard:SDCardisread-onlywhenitislocked.Nophotosorvideoscan

be recorded when the SDcard is locked. Make sure

the lock is on thewriteable position before recording

anymedia.

Writeable

position

Write-Protected

Position

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

No comments

ViewSonic VC320 User's Guide Page 12